WATERSAVERS "SAVINGS WITH COMFORT"
Settings & Installation for TAPs
RA6 22
RA6 24
RA6 22/24 - Universal
RA6 22 V - Flexible
RA6 24 V - Flexible
RA6 22 GOLD
RA6 24 GOLD
Configuration
- 4 l/min – 2x thick black O-Rings.
- 6 l/min – 1x thick black O-Ring – DEFAULT SETTING
- 8 l/min – 1x red O-Ring.
- 10 l/min – 2x thin black O-Rings.
- 12 l/min – 1x thin black O-Ring.
- 14 l/min – without O-Ring.
A sifter - for water containing coarse dirt particles – is a part of a basic delivery.
Set Up
Step 1: Remove seal from metal fitting.
Step 2: Remove plastic body from metal fitting.
Step 3: Remove a sifter.
Step 4: Remove the upside part of the restrictor.
Step 5: Push out an O-ring with pointed instrument.
Step 6: Remove O-ring from the flow restrictor.
Step 7: Insert an O-ring or combination of O-rings and then assembly all the parts back together.
Installation
Installation of our water flow restrictors is very simple. It is easy to manage without using special tools.
Before you install the water flow restrictor consider if you want to keep the default flow rate setting or if you want to change it.
Step 1: Screw the old aerator off.
Step 2: Use your finger to remove gross filth from the thread of the tap. Wash the filth settled in the tap away.
Step 3: Screw water flow restrictor on. Make sure that the water flow restrictor is screwed on straight and tight, otherwise water splashing may come about.
Step 4: If you are not strong enought to tighten the water flow restrictor completly with your hand - use pliers.
Step 5: If the water flow restrictor doesn´t fit well on the thread of the tap or cause water splashing, remove it and start again.
Step 6: If you have problems with installation or if your water flow restrictor causes water splashing despite the right selection of it and correct installation please contact us.
Please "Like
What makes WATERSAVERS unique?
EVERY
DROP
COUNTS
save water...
...save life